Introduction: Welcome to the ARMOR 4 with two-wire harness installation tutorial. Keith Bunch is here to guide you through the process, ensuring a smooth and effective setup.
Installation Steps:
Preparation:
- Unplug the batteries of the vehicle or machine to ensure safety during the installation.
Locating Power Source:
- Identify a power source within the vehicle or machine that provides 9 to 90 volts. This will be used to power the ARMOR 4 device.
Harness Installation:
- Install the ARMOR harness into the identified power source.
- Connect the ARMOR 4 device to the installed harness.
Device Activation:
- Once connected, verify that the lights on the ARMOR 4 device illuminate both red and green, indicating proper functioning.
Testing Device Functionality:
- Navigate to ARMOR Device Check and run your machine for 2 minutes.
- Enter your 15-digit IMEI in the provided field and click 'Check Device'.
- You should see three checks indicating successful connectivity, data reporting, and utilization.
Register the Device:
- Take a photo of the IMEI sticker alongside the machine's serial number tag.
- Email this photo to support@armordata.com and attach it to your work ticket for record-keeping.
Conclusion: Thank you for following this installation guide. Keith Bunch and everyone at ARMORdata.com appreciate your dedication to ensuring a correct setup. For further assistance or queries, feel free to contact our support team via our website ARMORdata.com.